• 网站首页
  • 关于Yabo下载
  • 新闻动态
  • 产品展示
  • 厂区厂貌
  • 在线留言
  • 联系我们
  • 热线电话:13472265816

    新闻动态您当前的位置是:首页>>>> 新闻动态

    亚博app下载安卓泵头部分组装
    作者: 更新日期:2019-12-09 16:37:13 浏览次数:

     亚博app下载安卓泵头部分组装

    首先在轴上装拆卸环、轴套、期间需要安装相应“0”型圈,接着吊装泵体,
    将泵体用螺栓紧固在托架上:安装机械密封组件(至待调节间隙、待压紧状态)或者
    减压盖、密封胶垫:吊装后护板,用螺栓紧固在泵体上;放叶轮“0”型圈,吊装
    叶轮、护套、用螺栓及固定压板将护套压在泵体上,在泵盖部分装上密封垫、前护
    板、再合装泵体、泵盖;然后紧固泵盖螺柱,注意泵盖螺柱应对称拧紧。另外,在
    装配时应当注意各密封垫必须放在正确位置上并保证压紧。
    该系列泵带有拆卸环,拆卸环上的三个内六角螺栓必须用黄油封住,以防锈蚀。
    拆卸时应先拆卸其上的三个内六角螺栓,将其拧入拆卸环上的另三个螺孔中,从轴
    上项起拆卸环的三个环块,然后才 能松开叶轮。
    Pump head assembly of slurry pump
    First, install the disassembly ring and sleeve on the shaft. During the installation, install the corresponding "0" ring, and then lift the pump body,
    Fasten the pump body to the bracket with bolts: install the mechanical seal assembly (to the gap to be adjusted, to be pressed) or
    Pressure relief cover and sealant pad: lift the rear guard board and fasten it on the pump body with bolts; place the impeller "0" ring and lift it
    The impeller, sheath, bolt and fixed pressing plate are used to press the sheath on the pump body, and the sealing gasket and front guard are installed on the pump cover
    Plate, reassemble the pump body and pump cover; then fasten the bolts of pump cover, and pay attention to the bolts of pump cover should be tightened symmetrically. In addition,
    During assembly, it should be noted that each gasket must be placed in the correct position and be tightly pressed.
    This series of pumps are equipped with a disassembly ring. The three hexagon socket bolts on the disassembly ring must be sealed with butter to prevent rust.
    When removing, first remove the three hexagon socket bolts, screw them into the other three screw holes on the removal ring, and screw them from the shaft
    Remove the three ring blocks of the ring before loosening the impeller.
  • 版权所有:河北Yabo下载泵业有限公司
  • 电话:0312-3596262
  • 地址:保定市安国市石佛镇石佛村